Chapter 5: Switching Commands 385
Provisioning (IEEE 802.1p) Commands
This section describes the commands you use to configure provisioning (IEEE
802.1p,) which allows you to prioritize ports.
vlan port priority all This command configures the port priority assigned for untagged packets for all
ports presently plugged into the device. The range for the priority is 0-7. Any
subsequent per port configuration will override this configuration setting.
vlan priority This command configures the default 802.1p port priority assigned for untagged
packets for a specific interface. The range for the priority is 0–7.
Format
vlan port priority all
priority
Mode Global Config
Default 0
Format
vlan priority
priority
Mode Interface Config
To Next Page
Loading...
