Chapter 2: Using the Command-Line Interface 25
Using CLI Help
Enter a question mark (?) at the command prompt to display the commands
available in the current mode:
(CN1610)>?
enable Enter into user privilege mode.
help Display help for various special keys.
logout Exit this session. Any unsaved changes are lost.
password Change an existing user’s password.
ping Send ICMP echo packets to a specified IP address.
quit Exit this session. Any unsaved changes are lost.
show Display Switch Options and Settings.
telnet Telnet to a remote host.
Enter a question mark (?) after each word you enter to display available
command keywords or parameters:
(CN1610)#network ?
ipv6 Configure IPv6 parameters for system network.
mac-address Configure MAC Address.
mac-type Select the locally administered or burnedin MAC
address.
mgmt_vlan Configure the Management VLAN ID of the switch.
parms Configure Network Parameters of the device.
protocol Select DHCP, BootP, or None as the network config
protocol.
If the help output shows a parameter in angle brackets, you must replace the
parameter with a value:
(CN1610)#network parms ?
<ipaddr> Enter the IP address.
If there are no additional command keywords or parameters, or if additional
parameters are optional, the following message appears in the output:
<cr> Press Enter to execute the command
To Next Page
Loading...
