NetApp CN1610 - No Lacp Partner System Priority; Interface Lag; Port-Channel Static; No Port-Channel Static

454 Port-Channel/LAG (802.3ad) Commands
Note
This command is applicable only to physical interfaces.
no lacp partner
system priority
Use this command to configure the default administrative value of priority
associated with the Partner’s System ID.
interface lag Use this command to enter Interface configuration mode for the specified LAG.
port-channel static This command enables the static mode on a port-channel (LAG) interface or
range of interfaces. By default the static mode for a new port-channel is enabled,
which means the port-channel is static. If the maximum number of allowable
dynamic port-channels are already present in the system, the static mode for a
new port-channel is enabled, which means the port-channel is static. You can
only use this command on port-channel interfaces.
no port-channel
static
This command sets the static mode on a particular port-channel (LAG) interface
to the default value. This command will be executed only for interfaces of type
port-channel (LAG).
Format
no lacp partner system priority
Mode Interface Config
Format
interface lag lag-interface-number
Mode Global Config
Default enabled
Format
port-channel static
Mode Interface Config
Format
no port-channel static
Mode Interface Config