NetApp CN1610 - Auto-Negotiate All; No Auto-Negotiate All; Description; Mtu

310 Port Configuration Commands
auto-negotiate all This command enables automatic negotiation on all ports.
no auto-negotiate
all
This command disables automatic negotiation on all ports.
description Use this command to create an alpha-numeric description of an interface or range
of interfaces.
mtu Use the
mtu command to set the maximum transmission unit (MTU) size, in
bytes, for frames that ingress or egress the interface. You can use the
mtu
command to configure jumbo frame support for physical and port-channel (LAG)
interfaces. For the standard FASTPATH implementation, the MTU size is a valid
integer between 1522–9216 for tagged packets and a valid integer between 1518 -
9216 for untagged packets.
Format
no auto-negotiate
Mode Interface Config
Default enabled
Format
auto-negotiate all
Mode Global Config
Format
no auto-negotiate all
Mode Global Config
Format
description description
Mode Interface Config