NetApp CN1610 - Snapshot Multicast; Snapshot System; Telnetd

Chapter 4: Utility Commands 273
snapshot multicast Use this command in Support mode to dump a set of IP multicast debug
information to capture the current state of multicast on the switch. The output is
written to the console and can be extensive.
snapshot system Use this command in Support mode to dump a set of system debug information to
capture the current state of the device. The output is written to the console and
can be extensive.
telnetd Use this command in Support mode to start or stop the Telnet daemon on the
switch.
Mode Support
Format
snapshot multicast
Mode Support
Format
snapshot multicast
Mode Support
Format
telnetd {start | stop}
Mode Support