NetApp CN1610 - Show Access-Lists

Chapter 7: Quality of Service Commands 673
The following shows example CLI display output for the command.
(CN1610) #show ip access-lists ip1
ACL Name: ip1
Inbound Interface(s): 1/0/30
Rule Number: 1
Action......................................... permit
Match All...................................... FALSE
Protocol....................................... 1(icmp)
Committed Rate................................. 32
Committed Burst Size........................... 16
show access-lists This command displays IP ACLs, IPv6 ACLs, and MAC access control lists
information for a designated interface and direction. Instead of slot/port
, lag
lag-intf-num
can be used as an alternate way to specify the LAG interface. lag
lag-intf-num
can also be used to specify the LAG interface where lag-intf-
num
is the LAG port number.Use the control-plane keyword to display the ACLs
applied on the CPU port.
Mirror Interface The unit/slot/port to which packets matching this
rule are copied.
Redirect Interface The unit/slot/port to which packets matching this
rule are forwarded.
Time Range Name Displays the name of the time-range if the IP ACL
rule has referenced a time range.
Rule Status Status (Active/Inactive) of the IP ACL rule.
Term Definition
Format
show access-lists interface {slot/port in|out |
control-plane}
Mode Privileged EXEC