Chapter 5: Switching Commands 387
show flowcontrol Use this command to display the IEEE 802.3 Annex 31B flow control settings
and status for a specific interface or all interfaces. The command also displays
802.3 Tx and Rx pause counts. Priority Flow Control frames counts are not
displayed. If the port is enabled for priority flow control, operational flow control
status is displayed as Inactive.
The following shows example CLI display output for the command.
(CN1610)#show flowcontrol
Admin Flow Control: Symmetric
Port Flow Control RxPause TxPause
Oper
------ ------------ -------- ---------
0/1 Active 310 611
0/2 Inactive 0 0
The following shows example CLI display output for the command.
(CN1610)#show flowcontrol interface 0/1
Admin Flow Control: Symmetric
Port Flow Control RxPause TxPause
Oper
--------- ------- -------- -------
0/1 Active 310 611
Format
no flowcontrol
Mode Global Config
Format
show flowcontrol [slot/port]
Mode Privileged EXEC
To Next Page
Loading...
