Chapter 3: Management Commands 103
show snmp
engineID
This command displays the currently configured SNMP engineID.
show snmp filters This command displays the configured filters used when sending traps.
Host Table: Target Address The address of the host that traps will
be sent to.
Type The type of message that will be sent,
either traps or informs.
Community The community traps will be sent to.
Version The version of SNMP the trap will be
sent as.
UDP Port The UDP port the trap or inform will
be sent to.
Filter name The filter the traps will be limited by
for this host.
TO Sec The number of seconds before informs
will time out when sending to this
host.
Retries The number of times informs will be
sent after timing out.
Term Definition
Format
show snmp engineID
Mode Privileged EXEC
Parameter Description
Local SNMP EnginID The current configuration of the displayed SNMP
engineID.
To Next Page
Loading...
