NetApp CN1610 - Show Logging Persistent

Chapter 4: Utility Commands 199
The following shows example CLI display output for the command.
(CN1610) #show logging hosts ?
<cr> Press enter to execute the command.
| Output filter options.
(CN1610) #show logging hosts
Index IP Address/Hostname Severity Port Status
-------- ---------------------- ----------- ------ ---------
1 10.130.64.88 critical 514 Active
2 2000::150 critical 514 Active
show logging
persistent
Use the show logging persistent command to display persistent log entries. If
log-files is specified, the system persistent log files are displayed.
Term Definition
Host Index (Used for deleting hosts.)
IP Address /
Hostname
IP address or hostname of the logging host.
Severity Level The minimum severity to log to the specified
address. The possible values are emergency (0), alert
(1), critical (2), error (3), warning (4), notice (5),
info (6), or debug (7).
Port The server port number, which is the port on the
local host from which syslog messages are sent.
Host Status Status field provides the current status of snmp row
status. (Active, Not in Service, Not Ready).
Format
show logging persistent [log-files]
Mode Privileged EXEC
Parameter Description
Persistent Logging If persistent logging is enabled or disabled.