NetApp CN1610 - No Sflow Poller; Show Sflow Agent

280 sFlow Commands
no sflow poller Use this command to reset the sFlow poller instance to the default settings.
show sflow agent The sFlow agent collects time-based sampling of network interface statistics and
flow-based samples. These are sent to the configured sFlow receivers. Use this
command to display the sFlow agent information.
The following shows example CLI display output for the command.
(CN1610) #show sflow agent
Poll Interval Enter the sFlow instance polling interval. A poll
interval of zero (0) disables counter sampling. When
set to zero (0), all the poller parameters are set to
their corresponding default value. The range is 0-
86400. The default is 0. A value of N means once in
N seconds a counter sample is generated.
Field Description
Format
no sflow poller [interval]
Mode Interface Config
Format
show sflow agent
Mode Privileged EXEC
Field Description
sFlow Version Uniquely identifies the version and implementation
of this MIB. The version string must have the
following structure: MIB Version; Organization;
Software Revision where:
◆ MIB Version: 1.3, the version of this MIB.
◆ Organization: Broadcom Corp.
◆ Revision: 1.0
IP Address The IP address associated with this agent.