NetApp CN1610 - No Monitor Session

Chapter 5: Switching Commands 467
To configure the RSPAN VLAN source:
monitor session session-id source {interface unit/slot/port |
vlan
vlan-id | remote vlan vlan-id }[rx/tx]
To the configure RSPAN VLAN destination:
monitor session session-id destination {interface unit/slot/port
|remote vlan
vlan-id reflector-port unit/slot/port }
To attach an ACL:
monitor session session-id filter {ip access-group acl-
id/aclname
|mac access-group acl-name }
no monitor session Use this command without optional parameters to remove the monitor session
(port monitoring) designation from the source probe port, the destination
monitored port and all VLANs. Once the port is removed from the VLAN, you
must manually add the port to any desired VLANs. Use the
source interface
slot/port parameter or destination interface to remove the specified
interface from the port monitoring session. Use the
mode parameter to disable the
administrative mode of the session
Note
Since the current version of FASTPATH software only supports one session, if
you do not supply optional parameters, the behavior of this command is similar
to the behavior of the
no monitor command.
Format
monitor session session-id {source {interface
slot/port
| vlan vlan-id | remote vlan vlan-id }[{rx |
tx}] | destination {interface slot/port |remote vlan
vlan-id reflector-port unit/slot/port }| mode | filter
{ip access-group
acl-id/aclname |mac access-group
acl-name }}
Mode Global Config
Format
no monitor session session-id [{source interface
slot/port | destination interface | mode |filter {ip
access-group |mac access-group}}]
Mode Global Config