NetApp CN1610 - Show Radius Servers Command

Chapter 3: Management Commands 115
The following shows example CLI display output for the command.
(CN1610) #show radius
Number of Configured Authentication Servers............. 32
Number of Configured Accounting Servers................. 32
Number of Named Authentication Server Groups............ 15
Number of Named Accounting Server Groups................ 3
Number of Retransmits................................... 4
Time Duration........................................... 10
RADIUS Accounting Mode............................. Disable
RADIUS Attribute 4 Mode............................. Enable
RADIUS Attribute 4 Value ..................... 192.168.37.60
show radius servers This command displays the summary and details of RADIUS authenticating
servers configured for the RADIUS client.
Number of Named
Authentication
Server Groups
The number of configured named RADIUS server
groups.
Number of Named
Accounting Server
Groups
The number of configured named RADIUS server
groups.
Number of
Retransmits
The configured value of the maximum number of
times a request packet is retransmitted.
Time Duration
The configured timeout value, in seconds, for
request retransmissions.
RADIUS Accounting
Mode
A global parameter to indicate whether or not the
accounting mode for all the servers is enabled.
RADIUS Attribute 4
Mode
A global parameter to indicate whether the NAS-IP-
Address attribute has been enabled for use in
RADIUS requests.
RADIUS Attribute 4
Value
A global parameter that specifies the IP address to
be used in the NAS-IP-Address attribute of
RADIUS requests.
Output Description