NetApp CN1610 - Show Interfaces Switchport Command

380 Switch Ports
(CN1610) #show interfaces switchport
Port: 1/0/1
VLAN Membership Mode: General
Access Mode VLAN: 1 (default)
General Mode PVID: 1 (default)
General Mode Ingress Filtering: Disabled
General Mode Acceptable Frame Type: Admit all
General Mode Dynamically Added VLANs:
General Mode Untagged VLANs: 1
General Mode Tagged VLANs:
General Mode Forbidden VLANs:
Trunking Mode Native VLAN: 1 (default)
Trunking Mode Native VLAN tagging: Disable
Trunking Mode VLANs Enabled: All
Protected Port: False
show interfaces
switchport
Use this command to display the Switchport configuration for a selected mode
per interface. If the interface is not specified, the configuration for all interfaces is
displayed.
Switching) # show interfaces switchport access 1/0/1
Intf PVID
--------- ----
1/0/1 1
(Switching) # show interfaces switchport trunk 1/0/6
Intf PVID Allowed Vlans List
--------- ----- -------------------
1/0/6 1 All
(Switching) # show interfaces switchport general 1/0/5
Intf PVID Ingress Acceptable Untagged Tagged Forbidden
Dynamic
Format
show interfaces switchport {access | trunk | general}
[slot/port]
Mode Privileged EXEC