NetApp CN1610 - No Snmp-Server Engineid Local; Snmp-Server Filter

Chapter 3: Management Commands 95
CAUTION
Changing the engine-id will invalidate all SNMP configuration that exists on
the box.
no snmp-server
engineID local
This command removes the specified engine ID.
snmp-server filter This command creates a filter entry for use in limiting which traps will be sent to
a host.
default Sets the engine-id to the default string, based on the
device MAC address.
Parameter Description
Default The engineID is configured automatically, based on the device
MAC address.
Format
no snmp-server engineID local
Mode Global Config
Default No filters are created by default.
Format
snmp-server filter filtername oid-tree
{included|excluded}
Mode Global Config
Parameter Description
filtername The label for the filter being created. The range is 1
to 30 characters.
oid-tree The OID subtree to include or exclude from the
filter. Subtrees may be specified by numerical
(1.3.6.2.4) or keywords (system), and asterisks may
be used to specify a subtree family (1.3.*.4).