468 Port Mirroring Commands
no monitor This command removes all the source ports and a destination port for the and
restores the default value for mirroring session mode for all the configured
sessions.
This is a stand-alone “no” command. This command does not have a “normal”
form.
show monitor
session
This command displays the Port monitoring information for a particular
mirroring session.
The
session-id parameter is an integer value used to identify the session and
ranges from 1–4.
Default enabled
Format
no monitor
Mode Global Config
Format
show monitor session
session-id
Mode Privileged EXEC
Term Definition
Session ID An integer value used to identify the session. Its
value can be anything between 1 and the maximum
number of mirroring sessions allowed on the
platform.
Monitor Session
Mode
Indicates whether the Port Mirroring feature is
enabled or disabled for the session identified with
session-id. The possible values are Enabled and
Disabled.
Probe Port Probe port (destination port) for the session
identified with
session-id. If probe port is not set
then this field is blank.
To Next Page
Loading...
