NetApp CN1610 - Transport Input Telnet; No Transport Input Telnet; Transport Output Telnet; No Transport Output Telnet

42 Telnet Commands
transport input
telnet
This command regulates new Telnet sessions. If enabled, new Telnet sessions can
be established until there are no more sessions available. An established session
remains active until the session is ended or an abnormal network error ends the
session.
Note
If the Telnet Server Admin Mode is disabled, Telnet sessions cannot be
established. Use the
ip telnet server enable command to enable Telnet
Server Admin Mode.
no transport input
telnet
Use this command to prevent new Telnet sessions from being established.
transport output
telnet
This command regulates new outbound Telnet connections. If enabled, new
outbound Telnet sessions can be established until the system reaches the
maximum number of simultaneous outbound Telnet sessions allowed. An
established session remains active until the session is ended or an abnormal
network error ends it.
no transport output
telnet
Use this command to prevent new outbound Telnet connection from being
established.
Default enabled
Format
transport input telnet
Mode Line Config
Format
no transport input telnet
Mode Line Config
Default enabled
Format
transport output telnet
Mode Line Config
Format
no transport output telnet
Mode Line Config