Chapter 5: Switching Commands 479
no dhcp l2relay
remote-id vlan
This parameter clears the DHCP Option-82 Remote ID for a VLAN and
subscribed service (based on subscription-name).
dhcp l2relay trust Use this command to configure an interface or range of interfaces as trusted for
Option-82 reception.
no dhcp l2relay
trust
Use this command to configure an interface to the default untrusted for Option-
82 reception.
dhcp l2relay vlan Use this command to enable the DHCP L2 Relay agent for a set of VLANs. All
DHCP packets which arrive on interfaces in the configured VLAN are subject to
L2 Relay processing.
Parameter Description
vlan–list The VLAN ID. The range is 1–4093. Separate
nonconsecutive IDs with a comma (,) no spaces and
no zeros in between the range. Use a dash (–) for the
range.
Format
no dhcp l2relay remote-id vlan vlan-list
Mode Global Config
Default untrusted
Format
dhcp l2relay trust
Mode Interface Config
Format
no dhcp l2relay trust
Mode Interface Config
Default
disable
To Next Page
Loading...
