NetApp CN1610 - No Lacp Partner Admin State Individual; Lacp Partner Admin State Longtimeout; No Lacp Partner Admin State Longtimeout; No Lacp Partner Admin State Passive

Chapter 5: Switching Commands 451
no lacp partner
admin state
individual
Use this command to set the LACP partner admin state to aggregation.
lacp partner admin
state longtimeout
Use this command to set LACP partner admin state to longtimeout.
Note
This command is applicable only to physical interfaces.
no lacp partner
admin state
longtimeout
Use this command to set the LACP partner admin state to short timeout.
Note
This command is applicable only to physical interfaces.
lacp partner admin
state passive
Use this command to set the LACP partner admin state to passive.
Note
This command is applicable only to physical interfaces.
Format
no lacp partner admin state individual
Mode Interface Config
Format
lacp partner admin state longtimeout
Mode Interface Config
Format
no lacp partner admin state longtimeout
Mode Interface Config
Format
lacp partner admin state passive
Mode Interface Config