Chapter 4: Utility Commands 149
The display parameters, when the argument is “switchport” are as follows:
show interfaces
status
Use this command to display interface information, including the description,
port state, speed and auto-neg capabilities. The command is similar to
show port
all
but displays additional fields like interface description and port-capability.
Time Since Counters
Last Cleared
The elapsed time, in days, hours, minutes, and
seconds since the statistics for this port were last
cleared.
Term Definition
Packets Received
Without Error
The total number of packets (including broadcast
packets and multicast packets) received by the
processor.
Broadcast Packets
Received
The total number of packets received that were
directed to the broadcast address. Note that this does
not include multicast packets.
Packets Received
With Error
The number of inbound packets that contained errors
preventing them from being deliverable to a higher-
layer protocol.
Packets Transmitted
Without Error
The total number of packets transmitted out of the
interface.
Broadcast Packets
Transmitted
The total number of packets that higher-level
protocols requested to be transmitted to the
Broadcast address, including those that were
discarded or not sent.
Transmit Packet
Errors
The number of outbound packets that could not be
transmitted because of errors.
Time Since Counters
Last Cleared
The elapsed time, in days, hours, minutes, and
seconds since the statistics for this switch were last
cleared.
Parameters Definition
To Next Page
Loading...
