522 IGMP Snooping Querier Commands
no set igmp querier
election participate
Use this command to set the Snooping Querier not to participate in querier
election but go into non-querier mode as soon as it discovers the presence of
another querier in the same VLAN.
show
igmpsnooping
querier
Use this command to display IGMP Snooping Querier information. Configured
information is displayed whether or not IGMP Snooping Querier is enabled.
When the optional argument
vlanid is not used, the command displays the
following information.
Format
no set igmp querier election participate
Mode VLAN Config
Format
show igmpsnooping querier [{detail | vlan
vlanid
}]
Mode Privileged EXEC
Field Description
Admin Mode Indicates whether or not IGMP Snooping Querier is
active on the switch.
Admin Version The version of IGMP that will be used while sending
out the queries.
Querier Address The IP Address which will be used in the IPv4
header while sending out IGMP queries. It can be
configured using the appropriate command.
Query Interval The amount of time in seconds that a Snooping
Querier waits before sending out the periodic
general query.
Querier Timeout The amount of time to wait in the Non-Querier
operational state before moving to a Querier state.
To Next Page
Loading...
