NetApp CN1610 - Erase Startup-Config; Erase Factory-Defaults; Show Autoinstall

Chapter 4: Utility Commands 139
erase startup-config Use this command to erase the text-based configuration file stored in non-volatile
memory. If the switch boots and no startup-config file is found, the AutoInstall
process automatically begins.
erase factory-
defaults
Use this command to erase the text-based factory-defaults file stored in non-
volatile memory.
show autoinstall This command displays the current status of the AutoInstall process.
The following shows example CLI display output for the command.
(CN1610) #show autoinstall
AutoInstall Mode............................... Stopped
AutoInstall Persistent Mode.................... Disabled
AutoSave Mode.................................. Disabled
AutoReboot Mode................................ Enabled
AutoInstall Retry Count........................ 3
Format
erase startup-config
Mode Privileged EXEC
Default Disable
Format
erase factory-defaults
Mode Privileged EXEC
Format
show autoinstall
Mode Privileged EXEC