288 Remote Monitoring Commands
The following shows an example of the command.
(CN1610) (Config)# rmon hcalarm 1 ifInOctets.1 30 absolute rising-
threshold high 1 low 100 status positive 1 falling-threshold high 1
low 10 status positive startup rising owner myOwner
no rmon hcalarm This command deletes the rmon hcalarm entry.
The following shows an example of the command.
(CN1610) (Config)# no rmon hcalarm 1
rmon event This command sets the RMON event entry in the RMON event MIB group.
High Capacity Alarm
Rising Event Index
The index of the eventEntry that is used when a
rising threshold is crossed. The range is 1 to 65535.
The default is 1.
High Capacity Alarm
Falling Event Index
The index of the eventEntry that is used when a
falling threshold is crossed. The range is 1 to 65535.
The default is 2.
High Capacity Alarm
Failed Attempts
The number of times the associated
hcAlarmVariable instance was polled on behalf of
the hcAlarmEntry (while in the active state) and the
value was not available. This object is a 32-bit
counter value that is read-only.
High Capacity Alarm
Owner
The owner string associated with the alarm entry.
The default is monitorHCAlarm.
High Capacity Alarm
Storage Type
The type of non-volatile storage configured for this
entry. This object is read-only. The default is
volatile.
Parameter Description
Format
no rmon hcalarm alarm number
Mode Global Config
To Next Page
Loading...
