NetApp CN1610 - No Dot1 X Supplicant Port-Control; Dot1 X Supplicant Max-Start;No Dot1 X Supplicant Max-Start; Dot1 X Supplicant Timeout Start-Period; No Dot1 X Supplicant Timeout Start-Period

Chapter 5: Switching Commands 429
no dot1x supplicant
port-control
This command sets the port-control mode to the default, auto.
dot1x supplicant
max-start
This command configures the number of attempts that the supplicant makes to
find the authenticator before the supplicant assumes that there is no authenticator.
no dot1x supplicant
max-start
This command sets the max-start value to the default.
dot1x supplicant
timeout start-period
This command configures the start period timer interval to wait for the EAP
identity request from the authenticator.
no dot1x supplicant
timeout start-period
This command sets the start-period value to the default.
Default auto
Format
no dot1x supplicant port-control
Mode Interface Config
Default 3
Format
dot1x supplicant max-start <1-10>
Mode Interface Config
Format
no dot1x supplicant max-start
Mode Interface Config
Default 30 seconds
Format
dot1x supplicant timeout start-period <1-65535
seconds>
Mode Interface Config
Format
no dot1x supplicant timeout start-period
Mode Interface Config