NetApp CN1610 - No Telnetcon Maxsessions; Telnetcon Timeout; No Telnetcon Timeout

44 Telnet Commands
no telnetcon
maxsessions
This command sets the maximum number of Telnet connection sessions that can
be established to the default value.
telnetcon timeout This command sets the Telnet connection session timeout value, in minutes. A
session is active as long as the session has not been idle for the value set. The
time is a decimal value from 1 to 160.
Note
When you change the timeout value, the new value is applied to all active and
inactive sessions immediately. Any sessions that have been idle longer than the
new timeout value are disconnected immediately.
no telnetcon
timeout
This command sets the Telnet connection session timeout value to the default.
Note
Changing the timeout value for active sessions does not become effective until
the session is accessed again. Also, any keystroke activates the new timeout
duration.
Format
telnetcon maxsessions 0-5
Mode Privileged EXEC
Format
no telnetcon maxsessions
Mode Privileged EXEC
Default 5
Format
telnetcon timeout 1-160
Mode Privileged EXEC
Format
no telnetcon timeout
Mode Privileged EXEC