Chapter 4: Utility Commands 135
4
Utility Commands
This chapter describes the utility commands available in the FASTPATH CLI.
The Utility Commands chapter includes the following sections:
◆ “AutoInstall Commands” on page 136
◆ “CLI Output Filtering Commands” on page 140
◆ “Dual Image Commands” on page 143
◆ “System Information and Statistics Commands” on page 145
◆ “Logging Commands” on page 193
◆ “Email Alerting and Mail Server Commands” on page 202
◆ “System Utility and Clear Commands” on page 210
◆ “Simple Network Time Protocol Commands” on page 225
◆ “Simple Network Time Protocol Commands” on page 225
◆ “Time Zone Commands” on page 231
◆ “DNS Client Commands” on page 237
◆ “IP Address Conflict Commands” on page 243
◆ “Serviceability Packet Tracing Commands” on page 244
◆ “sFlow Commands” on page 275
◆ “sFlow Commands” on page 275
◆ “Remote Monitoring Commands” on page 284
The commands in this chapter are in one of four functional groups:
◆ Show commands display switch settings, statistics, and other information.
◆ Configuration commands configure features and options of the switch. For
every configuration command, there is a show command that displays the
configuration setting.
◆ Copy commands transfer or save configuration and informational files to and
from the switch.
◆ Clear commands clear some or all of the settings to factory defaults.
To Next Page
