NetApp CN1610 - No Storm-Control Broadcast; Storm-Control Broadcast Level; No Storm-Control Broadcast Level

434 Storm-Control Commands
broadcast traffic ingressing on an interface increases beyond the configured
threshold, the traffic will be dropped. Therefore, the rate of broadcast traffic will
be limited to the configured threshold.
no storm-control
broadcast
Use this command to disable broadcast storm recovery mode for all interfaces
(Global Config mode) or one or more interfaces (Interface Config mode).
storm-control
broadcast level
Use this command to configure the broadcast storm recovery threshold for all
interfaces (Global Config mode) or one or more interfaces (Interface Config
mode) as a percentage of link speed and enable broadcast storm recovery. If the
mode is enabled, broadcast storm recovery is active, and if the rate of L2
broadcast traffic ingressing on an interface increases beyond the configured
threshold, the traffic is dropped. Therefore, the rate of broadcast traffic is limited
to the configured threshold.
no storm-control
broadcast level
This command sets the broadcast storm recovery threshold to the default value
for all interfaces (Global Config mode) or one or more interfaces (Interface
Config mode) and disables broadcast storm recovery.
Default disabled
Format
storm-control broadcast
Mode ◆ Global Config
◆ Interface Config
Format
no storm-control broadcast
Mode ◆ Global Config
◆ Interface Config
Default 5
Format
storm-control broadcast level 0-100
Mode ◆ Global Config
◆ Interface Config