NetApp CN1610 - Simple Network Time Protocol Commands; Sntp Broadcast Client Poll-Interval; No Sntp Broadcast Client Poll-Interval; Sntp Client Mode;No Sntp Client Mode

Chapter 4: Utility Commands 225
Simple Network Time Protocol Commands
This section describes the commands you use to automatically configure the
system time and date by using Simple Network Time Protocol (SNTP).
sntp broadcast
client poll-interval
This command sets the poll interval for SNTP broadcast clients in seconds as a
power of two where
poll-interval can be a value from 6 to 10.
no sntp broadcast
client poll-interval
This command resets the poll interval for SNTP broadcast client back to the
default value.
sntp client mode This command enables Simple Network Time Protocol (SNTP) client mode and
may set the mode to either broadcast or unicast.
no sntp client mode This command disables Simple Network Time Protocol (SNTP) client mode.
Default 6
Format
sntp broadcast client poll-interval poll-interval
Mode Global Config
Format
no sntp broadcast client poll-interval
Mode Global Config
Default disabled
Format
sntp client mode [ broadcast | unicast ]
Mode Global Config
Format
no sntp client mode
Mode Global Config