NetApp CN1610 - No Debug Ping Packet; Debug Sflow Packet; No Debug Sflow Packet

258 Serviceability Packet Tracing Commands
no debug ping
packet
This command disables tracing of ICMP echo requests and responses.
debug sflow packet Use this command to enable sFlow debug packet trace.
no debug sflow
packet
Use this command to disable sFlow debug packet trace.
Parameter Definition
TX/RX TX refers to a packet transmitted by the device. RX
refers to packets received by the device.
Intf The interface that the packet came in or went out on.
Format used is unit/slot/port (internal interface
number). Unit is always shown as 1.
SRC_IP The source IP address in the IP header in the packet.
DEST_IP The destination IP address in the IP header in the
packet.
Type Type determines whether or not the ICMP message
is a REQUEST or a RESPONSE.
Format
no debug ping packet
Mode Privileged EXEC
Default disabled
Format
debug sflow packet
Mode Privileged EXEC
Format
no debug sflow packet
Mode Privileged EXEC