Chapter 3: Management Commands 65
no username
snmpv3 encryption
This command sets the encryption protocol to none. The username is the login
user name for which the specified encryption protocol will be used.
username snmpv3
encryption
encrypted
This command specifies the des encryption protocol and the required encryption
key for the specified user. The encryption key
must be 8 to 64 characters long.
show users This command displays the configured user names and their settings. The
show
users
command displays truncated user names. Use the
show users long
command to display the complete usernames. The
show users
command is only
available for users with Level 15 privileges. The SNMPv3 fields will only be
displayed if SNMP is available on the system.
Format
no username snmpv3 encryption
username
Mode Global Config
Default no encryption
Format
username snmpv3 encryption encrypted
username
des
key
Mode Global Config
Format
show users
Mode Privileged EXEC
Term Definition
User Name The name the user enters to login using the serial
port, SSH, or Telnet.
Access Mode Shows whether the user is able to change parameters
on the switch (Level 15) or is only able to view them
(Level 1). As a factory default, the “admin” user has
Level 15 access and the “guest” has Level 1 access.
To Next Page
Loading...
