NetApp CN1610 - Spanning-Tree Forward-Time; No Spanning-Tree Forward-Time; Spanning-Tree Guard; No Spanning-Tree Guard

Chapter 5: Switching Commands 325
spanning-tree
forward-time
This command sets the Bridge Forward Delay parameter to a new value for the
common and internal spanning tree. The forward-time value is in seconds within
a range of 4 to 30, with the value being greater than or equal to “(Bridge Max
Age / 2) + 1”.
no spanning-tree
forward-time
This command sets the Bridge Forward Delay parameter for the common and
internal spanning tree to the default value.
spanning-tree
guard
This command selects whether loop guard or root guard is enabled on an
interface or range of interfaces. If neither is enabled, then the port operates in
accordance with the multiple spanning tree protocol.
no spanning-tree
guard
This command disables loop guard or root guard on the interface.
Default 15
Format
spanning-tree forward-time 4-30
Mode Global Config
Format
no spanning-tree forward-time
Mode Global Config
Default none
Format
spanning-tree guard {none | root | loop}
Mode Interface Config
Format
no spanning-tree guard
Mode Interface Config