600 IPv6 Management Commands
The following is an example of the command.
(CN1610) #show network ipv6 neighbors
Neighbor Age
IPv6 Address MAC Address isRtr State (Secs)
Type
------------------------ ----------------- ----- --------- ------
------
FE80::5E26:AFF:FEBD:852C 5c:26:0a:bd:85:2c FALSE Reachable 0
Static
show serviceport
ipv6 neighbors
Use this command to displays information about the IPv6 neighbor entries
cached on the service port. The information is updated to show the type of the
entry.
Field Description
IPv6 Address The IPv6 address of the neighbor.
MAC Address The MAC Address of the neighbor.
isRtr Shows if the neighbor is a router. If TRUE, the
neighbor is a router; FALSE it is not a router.
Neighbor State The state of the neighbor cache entry. Possible
values are: Incomplete, Reachable, Stale, Delay,
Probe, and Unknown
Age The time in seconds that has elapsed since an entry
was added to the cache.
Last Updated The time in seconds that has elapsed since an entry
was added to the cache.
Type The type of neighbor entry. The type is Static if the
entry is manually configured and Dynamic if
dynamically resolved.
Default None
Format
show serviceport ipv6 neighbors
Mode Privileged EXEC
To Next Page
Loading...
