NetApp CN1610 - Network Interface Commands; Enable (Privileged EXEC Access); Do (Privileged EXEC Commands)

30 Network Interface Commands
Network Interface Commands
This section describes the commands you use to configure a logical interface for
management access. To configure the management VLAN, see “network
mgmt_vlan” on page 351.
enable (Privileged
EXEC access)
This command gives you access to the Privileged EXEC mode. From the
Privileged EXEC mode, you can configure the network interface.
do (Privileged EXEC
commands)
This command executes Privileged EXEC mode commands from any of the
configuration modes.
The following is an example of the
do command that executes the Privileged
EXEC command
script list in Global Config Mode.
(CN1610) #configure
(CN1610)(config)#do script list
Configuration Script Name Size(Bytes)
-------------------------------- -----------
backup-config 2105
running-config 4483
startup-config 445
3 configuration script(s) found.
2041 Kbytes free.
Format
enable
Mode User EXEC
Format
do Priv Exec Mode Command
Mode ◆ Global Config
◆ Interface Config
◆ VLAN Config