256 Serviceability Packet Tracing Commands
debug ipv6 dhcp This command displays “debug” information about DHCPv6 client activities and
traces DHCPv6 packets to and from the local DHCPv6 client.
no debug ipv6 dhcp This command disables the display of “debug” trace output for DHCPv6 client
activity.
debug lacp packet This command enables tracing of LACP packets received and transmitted by the
switch.
A sample output of the trace message is shown below.
<15> JAN 01 14:04:51 10.254.24.31-1 DOT3AD
[
183697744
]
:
dot3ad_debug.c(385) 58 %%
Pkt TX - Intf: 1/0/1(1), Type: LACP, Sys: 00:11:88:14:62:e1,
State: 0x47, Key:
0x36
no debug lacp
packet
This command disables tracing of LACP packets.
Default disabled
Format
debug ipv6 dhcp
Mode Privileged EXEC
Format
no debug ipv6 dhcp
Mode Privileged EXEC
Default disabled
Format
debug lacp packet
Mode Privileged EXEC
Format
no debug lacp packet
Mode Privileged EXEC
To Next Page
Loading...
