202 Email Alerting and Mail Server Commands
Email Alerting and Mail Server Commands
logging email This command enables email alerting and sets the lowest severity level for which
log messages are emailed. If you specify a severity level, log messages at or
above this severity level, but below the urgent severity level, are emailed in a non-
urgent manner by collecting them together until the log time expires. You can
specify the
severitylevel value as either an integer from 0 to 7 or
symbolically through one of the following keywords:
emergency (0), alert (1),
critical (2), error (3), warning (4), notice (5), info (6), or debug (7).
no logging email This command disables email alerting.
logging email
urgent
This command sets the lowest severity level at which log messages are emailed
immediately in a single email message. Specify the severitylevel value as
either an integer from 0 to 7 or symbolically through one of the following
keywords:
emergency (0), alert (1), critical (2), error (3), warning
(4), notice (5), info (6), or debug (7)
. Specify
none
to indicate that log
messages are collected and sent in a batch email at a specified interval.
Default disabled; when enabled, log messages at or above severity
Warning (4) are emailed
Format
logging email
[severitylevel]
Mode Global Config
Format
no logging email
Mode Global Config
Default Alert (1) and emergency (0) messages are sent immediately.
Format
logging email urgent {
severitylevel
| none}
Mode Global Config
To Next Page
Loading...
