Chapter 5: Switching Commands 439
active, and if the rate of L2 broadcast traffic ingressing on an interface increases
beyond the configured threshold, the traffic is dropped. Therefore, the rate of
unicast traffic is limited to the configured threshold.
no storm-control
unicast rate
This command sets the unicast storm recovery threshold to the default value for
all interfaces (Global Config mode) or one or more interfaces (Interface Config
mode) and disables unicast storm recovery.
show storm-control This command displays switch configuration information. If you do not use any
of the optional parameters, this command displays global storm control
configuration parameters:
◆ Broadcast Storm Recovery Mode may be enabled or disabled. The factory
default is disabled.
◆ 802.3x Flow Control Mode may be enabled or disabled. The factory default
is disabled.
Use the
all
keyword to display the per-port configuration parameters for all
interfaces, or specify the slot/port to display information about a specific
interface.
Default 0
Format
storm-control unicast rate
0-14880000
Mode ◆ Global Config
◆ Interface Config
Format
no storm-control unicast rate
Mode ◆ Global Config
◆ Interface Config
Format
show storm-control [all | slot/port]
Mode Privileged EXEC
To Next Page
Loading...
