NetApp CN1610 - Username Unlock; Username Snmpv3 Accessmode; No Username Snmpv3 Accessmode; Username Snmpv3 Authentication

Chapter 3: Management Commands 63
username unlock Use this command to allows a locked user account to be unlocked. Only a user
with Level 1 access can reactivate a locked user account.
username snmpv3
accessmode
This command specifies the snmpv3 access privileges for the specified login
user. The valid accessmode values are
readonly or readwrite. The username
is the login user name for which the specified access mode applies. The default is
readwrite for the “admin” user and readonly for all other users. You must enter
the
username in the same case you used when you added the user. To see the
case of the
username, enter the show users command.
no username
snmpv3
accessmode
This command sets the snmpv3 access privileges for the specified user as
readwrite for the “admin” user and readonly for all other users. The
username
value is the user name for which the specified access mode will apply.
username snmpv3
authentication
This command specifies the authentication protocol to be used for the specified
user. The valid authentication protocols are
none, md5 or sha. If you specify md5
or
sha, the login password is also used as the snmpv3 authentication password
and therefore must be at least eight characters in length. The
username is the
user name associated with the authentication protocol. You must enter the
username in the same case you used when you added the user. To see the case of
the
username, enter the show users command.
Format
username name unlock
Mode Global Config
Default
s
◆ admin - readwrite
◆ other - readonly
Format
username snmpv3 accessmode username { readonly |
readwrite
}
Mode Global Config
Format
no username snmpv3 accessmode username
Mode Global Config