NetApp CN1610 - Mode Dot1 Q-Tunnel; No Mode Dot1 Q-Tunnel; Mode Dvlan-Tunnel; No Mode Dvlan-Tunnel

370 Double VLAN Commands
mode dot1q-tunnel This command is used to enable Double VLAN Tunneling on the specified
interface.
no mode dot1q-
tunnel
This command is used to disable Double VLAN Tunneling on the specified
interface. By default, Double VLAN Tunneling is disabled.
mode dvlan-tunnel Use this command to enable Double VLAN Tunneling on the specified interface.
Note
When you use the mode dvlan-tunnel command on an interface, it becomes a
service provider port. Ports that do not have double VLAN tunneling enabled are
customer ports.
no mode dvlan-
tunnel
This command is used to disable Double VLAN Tunneling on the specified
interface. By default, Double VLAN Tunneling is disabled.
Default disabled
Format
mode dot1q-tunnel
Mode Interface Config
Format
no mode dot1q-tunnel
Mode Interface Config
Default disabled
Format
mode dvlan-tunnel
Mode Interface Config
Format
no mode dvlan-tunnel
Mode Interface Config