NetApp CN1610 - Show Port-Channel System Priority; Show Port-Channel Counters

Chapter 5: Switching Commands 463
The following shows example CLI display output for the command.
(CN1610) #show port-channel 0/3/1
Local Interface................................ 0/3/1
Channel Name................................... ch1
Link State..................................... Up
Admin Mode..................................... Enabled
Type........................................... Static
Load Balance Option............................ 3
(Src/Dest MAC, VLAN, EType, incoming port)
Local Preference Mode.......................... Enabled
Mbr Device/ Port Port
Ports Timeout Speed Active
------ ------------- --------- -------
1/0/1 actor/long Auto True
partner/long
1/0/2 actor/long Auto True
partner/long
1/0/3 actor/long Auto False
partner/long
1/0/4 actor/long Auto False
partner/long
show port-channel
system priority
Use this command to display the port-channel system priority.
show port-channel
counters
Use this command to display port-channel counters for the specified port.
Port Speed Speed of the port-channel port.
Active Ports This field lists ports that are actively participating in
the port-channel (LAG).
Term Definition
Format
show port-channel system priority
Mode Privileged EXEC
Format
show port-channel slot/port counters