NetApp CN1610 - Show Rmon Log

Chapter 4: Utility Commands 299
Sample set: 1 Owner: myowner
Interface: 1/0/1 Interval: 30
Requested Samples: 10 Granted Samples: 10
Maximum table size: 1758
Time Dropped Collisions
-------------------- ------- ----------
Jan 01 1970 21:41:43 0 0
Jan 01 1970 21:42:14 0 0
Jan 01 1970 21:42:44 0 0
Jan 01 1970 21:43:14 0 0
Jan 01 1970 21:43:44 0 0
Jan 01 1970 21:44:14 0 0
Jan 01 1970 21:44:45 0 0
Jan 01 1970 21:45:15 0 0
Jan 01 1970 21:45:45 0 0
Jan 01 1970 21:46:15 0 0
show rmon log This command displays the entries in the RMON log table.
The following shows example CLI display output for the command.
(CN1610) #show rmon log
Event Description Time
------------------------------------------------
Format
show rmon log [event-index]
Mode Privileged EXEC
Parameter Description
Maximum table size Maximum number of entries that the log table can
hold.
Event Event index for which the log is generated.
Description A comment describing the event entry for which the
log is generated.
Time Time at which the event is generated.