Chapter 5: Switching Commands 391
GARP Commands
This section describes the commands you use to configure Generic Attribute
Registration Protocol (GARP) and view GARP status. The commands in this
section affect both GARP VLAN Registration Protocol (GVRP) and GARP
Multicast Registration Protocol (GMRP). GARP is a protocol that allows client
stations to register with the switch for membership in VLANS (by using GVMP)
or multicast groups (by using GVMP).
set garp timer join This command sets the GVRP join time per GARP for one interface, a range of
interfaces, or all interfaces. Join time is the interval between the transmission of
GARP Protocol Data Units (PDUs) registering (or reregistering) membership for
a VLAN or multicast group. This command has an effect only when GVRP is
enabled. The time is from 10 to 100 (centiseconds). The value 20 centiseconds is
0.2 seconds.
no set garp timer
join
This command sets the GVRP join time to the default and only has an effect
when GVRP is enabled.
set garp timer leave This command sets the GVRP leave time for one interface, a range of interfaces,
or all interfaces or all ports and only has an effect when GVRP is enabled. Leave
time is the time to wait after receiving an unregister request for a VLAN or a
multicast group before deleting the VLAN entry. This can be considered a buffer
time for another station to assert registration for the same attribute in order to
Default 20
Format
set garp timer join
10-100
Mode ◆ Interface Config
◆ Global Config
Format
no set garp timer join
Mode ◆ Interface Config
◆ Global Config
To Next Page
Loading...
