NetApp CN1610 - Show Classofservice Trust; Show Interfaces Cos-Queue

Chapter 7: Quality of Service Commands 613
The following information is repeated for each user priority.
show
classofservice trust
This command displays the current trust mode setting for a specific interface. If
you specify an interface, the command displays the port trust mode of the
interface. If you do not specify an interface, the command displays the most
recent global configuration settings.
show interfaces
cos-queue
This command displays the class-of-service queue configuration for the specified
interface. If specified, the class-of-service queue configuration of the interface is
displayed. If omitted, the most recent global configuration settings are displayed.
Term Definition
IP DSCP The IP DSCP value.
Traffic Class The traffic class internal queue identifier to which
the IP DSCP value is mapped.
Format
show classofservice trust [slot/port]
Mode Privileged EXEC
Term Definition
Class of Service Trust
Mode
The the trust mode, which is either Dot1P, IP DSCP,
or Untrusted.
Non-IP Traffic Class (IP DSCP mode only) The traffic class used for non-
IP traffic.
Untrusted Traffic
Class
(Untrusted mode only) The traffic class used for all
untrusted traffic.
Format
show interfaces cos-queue [slot/port]
Mode Privileged EXEC