NetApp CN1610 - Serviceport Ipv6 Gateway; No Serviceport Ipv6 Gateway; Serviceport Ipv6 Neighbor

596 IPv6 Management Commands
Use the command with the dhcp option to disable the dhcpv6 client protocol on
the service port.
serviceport ipv6
gateway
Use this command to configure IPv6 gateway (i.e. Default routers) information
for the service port.
Note
Only a single IPv6 gateway address can be configured for the service port. There
may be a combination of IPv6 prefixes and gateways that are explicitly
configured and those that are set through auto-address configuration with a
connected IPv6 router on their service port interface.
no serviceport ipv6
gateway
Use this command to remove IPv6 gateways on the service port interface.
serviceport ipv6
neighbor
Use this command to manually add IPv6 neighbors to the IPv6 neighbor table for
the service port. If an IPv6 neighbor already exists in the neighbor table, the entry
is automatically converted to a static entry. Static entries are not modified by the
Format
no serviceport ipv6 address { address/prefix-length
[eui64] | autoconfig | dhcp}
Mode Privileged EXEC
Format
serviceport ipv6 gateway gateway-address
Mode Privileged EXEC
Parameter Description
gateway-address Gateway address in IPv6 global or link-local address
format.
Format
no serviceport ipv6 gateway
Mode Privileged EXEC