NetApp CN1610 - Lacp Partner Port ID; No Lacp Partner Port ID; Lacp Partner Port Priority

452 Port-Channel/LAG (802.3ad) Commands
no lacp partner
admin state passive
Use this command to set the LACP partner admin state to active.
lacp partner port id Use this command to configure the LACP partner port id. This command can be
used to configure a single interface or a range of interfaces. The valid range for
port-id is 0 to 65535.
Note
This command is applicable only to physical interfaces.
no lacp partner port
id
Use this command to set the LACP partner port id to the default.
lacp partner port
priority
Use this command to configure the LACP partner port priority. This command
can be used to configure a single interface or a range of interfaces. The valid
range for
priority is 0 to 65535.
Note
This command is applicable only to physical interfaces.
Format
no lacp partner admin state passive
Mode Interface Config
Default 0x80
Format
lacp partner port-id port-id
Mode Interface Config
Format
no lacp partner port-id
Mode Interface Config
Default 0x0
Format
lacp partner port priority priority
Mode Interface Config