374 Private VLAN Commands
no switchport
private-vlan
This command removes the private-VLAN association or mapping from the port.
switchport mode
private-vlan
This command configures a port as a promiscuous or host private VLAN port.
Note that the properties of each mode can be configured even when the switch is
not in that mode. However, they will only be applicable once the switch is in that
particular mode.
no switchport mode
private-vlan
This command removes the private-VLAN association or mapping from the port.
private-vlan This command configures the private VLANs and configures the association
between the primary private VLAN and secondary VLANs.
Format
no switchport private-vlan {host-association|mapping}
Mode Interface Config
Default
general
Format
switchport mode private-vlan {host|promiscuous}
Mode Interface Config
Parameter Description
host Configures an interface as a private VLAN host port.
It can be either isolated or community port
depending on the secondary VLAN it is associated
with.
promiscuous Configures an interface as a private VLAN
promiscuous port. The promiscuous ports are
members of the primary VLAN.
Format
no switchport mode private-vlan
Mode Interface Config
To Next Page
Loading...
