NetApp CN1610 - VLAN Commands; Vlan Database; Network Mgmt_Vlan; No Network Mgmt_Vlan;Vlan

Chapter 5: Switching Commands 351
VLAN Commands
This section describes the commands you use to configure VLAN settings.
vlan database This command gives you access to the VLAN Config mode, which allows you to
configure VLAN characteristics
.
network mgmt_vlan This command configures the Management VLAN ID.
no network
mgmt_vlan
This command sets the Management VLAN ID to the default.
vlan This command creates a new VLAN and assigns it an ID. The ID is a valid
VLAN identification number (ID 1 is reserved for the default VLAN). VLAN
range is 2-4093.
Format
vlan database
Mode Privileged EXEC
Default 1
Format
network mgmt_vlan 1-4093
Mode Privileged EXEC
Format
no network mgmt_vlan
Mode Privileged EXEC
Format
vlan 2-4093
Mode VLAN Config