NetApp CN1610 - Show Rmon History

296 Remote Monitoring Commands
The following shows example CLI display output for the command.
(CN1610) # show rmon events
Index Description Type Community Owner Last time
sent
------------------------------------------------------------------
-------------
1 test log public MIB 0 days 0
h:0 m:0 s
show rmon history This command displays the specified entry in the RMON history table.
Format
show rmon history index {errors [period seconds]|other
[period seconds]|throughput [period seconds]}
Mode Privileged EXEC
Parameter Description
History Control Index An index that uniquely identifies an entry in the
historyControl table. Each such entry defines a set of
samples at a particular interval for an interface on
the device. The range is 1 to 65535.
History Control Data
Source
The source interface for which historical data is
collected.
History Control
Buckets Requested
The requested number of discrete time intervals over
which data is to be saved. The range is 1 to 65535.
The default is 50.
History Control
Buckets Granted
The number of discrete sampling intervals over
which data shall be saved. This object is read-only.
The default is 10.
History Control
Interval
The interval in seconds over which the data is
sampled. The range is 1 to 3600. The default is
1800.
History Control
Owner
The owner string associated with the history control
entry. The default is monitorHistoryControl.