NetApp CN1610 - No Ip Dhcp Snooping Limit; Ip Dhcp Snooping Log-Invalid; No Ip Dhcp Snooping Log-Invalid; Ip Dhcp Snooping Trust

490 DHCP Snooping Configuration Commands
no ip dhcp
snooping limit
Use this command to set the rate at which the DHCP Snooping messages come,
and the burst level, to the defaults.
ip dhcp snooping
log-invalid
Use this command to control the logging DHCP messages filtration by the DHCP
Snooping application. This command can be used to configure a single interface
or a range of interfaces.
no ip dhcp
snooping log-
invalid
Use this command to disable the logging DHCP messages filtration by the DHCP
Snooping application.
ip dhcp snooping
trust
Use this command to configure an interface or range of interfaces as trusted.
Default disabled (no limit)
Format
ip dhcp snooping limit {rate pps [ burst interval
seconds
]}
Mode Interface Config
Format
no ip dhcp snooping limit
Mode Interface Config
Default disabled
Format
ip dhcp snooping log-invalid
Mode Interface Config
Format
no ip dhcp snooping log-invalid
Mode Interface Config
Default disabled
Format
ip dhcp snooping trust