Chapter 5: Switching Commands 403
no dot1x dynamic-
vlan enable
Use this command to prevent the switch from creating VLANs when a RADIUS-
assigned VLAN does not exist in the switch.
dot1x guest-vlan This command configures VLAN as guest vlan on an interface or a range of
interfaces. The command specifies an active VLAN as an IEEE 802.1X guest
VLAN. The range is 1 to the maximum VLAN ID supported by the platform.
no dot1x guest-vlan This command disables Guest VLAN on the interface.
dot1x initialize This command begins the initialization sequence on the specified port. This
command is only valid if the control mode for the specified port is auto or mac-
based. If the control mode is not auto or mac-based, an error will be returned.
Format
no dot1x dynamic-vlan enable
Mode Global Config
Default disabled
Format
dot1x guest-vlan
vlan-id
Mode Interface Config
Default disabled
Format
no dot1x guest-vlan
Mode Interface Config
Format
dot1x initialize
slot/port
Mode Privileged EXEC
To Next Page
Loading...
