Chapter 5: Switching Commands 511
no set igmp fast-
leave
This command disables IGMP Snooping fast-leave admin mode on a selected
interface.
set igmp
groupmembership-
interval
This command sets the IGMP Group Membership Interval time on a VLAN, one
interface, a range of interfaces, or all interfaces. The Group Membership Interval
time is the amount of time in seconds that a switch waits for a report from a
particular group on a particular interface before deleting the interface from the
entry. This value must be greater than the IGMPv3 Maximum Response time
value. The range is 2 to 3600 seconds.
no set igmp
groupmembership-
interval
This command sets the IGMPv3 Group Membership Interval time to the default
value.
set igmp
maxresponse
This command sets the IGMP Maximum Response time for the system, on a
particular interface or VLAN, or on a range of interfaces. The Maximum
Response time is the amount of time in seconds that a switch will wait after
Format
no set igmp fast-leave [
vlan_id
]
Mode Interface Config
Interface Range
VLAN Config
Default 260 seconds
Format
set igmp groupmembership-interval [
vlan_id
]
2-3600
Mode ◆ Interface Config
◆ Global Config
◆ VLAN Config
Format
no set igmp groupmembership-interval [
vlan_id
]
Mode ◆ Interface Config
◆ Global Config
◆ VLAN Config
To Next Page
Loading...
