NetApp CN1610 - Spanning Tree Protocol Commands

Chapter 5: Switching Commands 315
--------- ------ --------- ---------- ---------- ------ ------- ---
--- --------
0/1 Enable Auto 100 Full Up Enable Enable
long
0/2 Enable Auto 100 Full Up Enable Enable
long
0/3 Enable Auto Down Enable Enable
long
0/4 Enable Auto 100 Full Up Enable Enable
long
0/5 Enable Auto 100 Full Up Enable Enable
long
0/6 Enable Auto 100 Full Up Enable Enable
long
0/7 Enable Auto 100 Full Up Enable Enable
long
0/8 Enable Auto 100 Full Up Enable Enable
long
1/1 Enable Down Disable N/A
N/A
1/2 Enable Down Disable N/A
N/A
1/3 Enable Down Disable N/A
N/A
1/4 Enable Down Disable N/A
N/A
1/5 Enable Down Disable N/A
N/A
1/6 Enable Down Disable N/A
N/A
show port advertise Use this command to display the local administrative link advertisement
configuration, local operational link advertisement, and the link partner
advertisement for an interface. It also displays priority Resolution for speed and
duplex as per 802.3 Annex 28B.3. It displays the Auto negotiation state, Phy
Master/Slave Clock configuration, and Link state of the port.
If the link is down, the Clock is displayed as No Link, and a dash is displayed
against the Oper Peer advertisement, and Priority Resolution. If Auto negotiation
is disabled, then the admin Local Link advertisement, operational local link
advertisement, operational peer advertisement, and Priority resolution fields are
not displayed.